SpeedFan - бесплатная программа, которая следит за температурой, скоростью движения кулера и напряжением. SpeedFan также может отображать температуру жесткого диска, если устройство поддерживает эту опцию. Однако, главной функцией SpeedFan является наблюдение за скоростью вращения кулера и ее изменение в зависимости от температуры внутри компьютера. Это помогает уменьшить шум и потребление электроэнергии.
SpeedFan monitors fan speeds, temperatures and voltages in computers with hardware monitor chips. It can even access S.M.A.R.T. info for those hard disks that support this feature and show hard disk temperatures too, if supported. It can even change the FSB on some hardware. At the lowest level, it is a hardware monitor software, but its main feature is that it can control fan speeds according to the temperatures inside your pc, thus reducing noise and power consumption.
Changes in SpeedFan 4.33 Final:
- completely rewritten the detection and the identification strategy of ITE IT871xF chips (fan readings are now ok)
- xAP support is now properly reenabled between sessions
- fixed context sensitive help (F1 key) on Windows Vista
- enabled, if needed, the SMBus on Intel ICH7 and ICH8-M
- added several checks to CPU usage routines, fixing a nasty issue where an error window appeared once every second
- added full support for ATI SB600 SMBus
- added full support for Intel ICH9 SMBus
- added full support for nVidia MCP55 SMBus
- added sull support for ADT7475
- added nVidia Control Panel access to read video card temperatures
- supported the IT8716F and the IT8718F hardware monitor at unusual addresses
- added some SMB scan exceptions for Compal 08A0
- SMBus address $15 no longer scanned on AOpen i975Xa-YDG
- fixed an issue that caused the DFI LP UT NF4 SLI-DR Venus to power off on program start
- added support for Fintek F71872F voltage readings
- IT8712F-J now uses two undocumented FAN DIVs
- speeded up Asus M2N32-SLI DELUXE program startup
- added detection of an unknown Fintek chip (to avoid false detection of other sensors at the same address)
- W83627EHF and W83627DHG now properly show SMARTFAN III in CONFIGURE / ADVANCED
- W83627EHF and W83627DHG can now change PWM TYPE from PWM to DC in CONFIGURE / ADVANCED
- fixed FAN DIVISOR settings for Winbond W83791D
- added PWM OUT BASE CLOCK selection for WINBOND W83627DHG, W83627EHF and W83627EHG
- warning temperature can now be set as high as 125C in CONFIGURE
Homepage - http://www.almico.com/speedfan.php
Размер: 1.6 Мб
Freeware
Download/Скачать